
Screw-On Impression and laboratory components
Screw-On impression and laboratory components are used to create a model of the patient's mouth and reproduce the position and orientation of the Screw-On abutments, which the dental laboratory uses to precise manufacture the prosthetic restoration. Both open tray impression and closed tray impression components and are available and are identical for both the BioniQ QR and QN Screw-On abutments. Do you make digital impressions and use 3D-printed models instead of traditional plaster ones? Order Screw-On abutment analog – 3D print.


Screw-On impression coping for open tray, d4.6

Screw-On impression coping for closed tray, d4.6

Spare cap (for Screw-On closed tray impression coping), set of 5 pcs.

Pin extension for open tray impresson components, set of 5 pcs.

Screw-On burn-out coping, d4.6

Screw-On burn-out coping, d4.6, set of 5 pcs. (without screws)

Screw-On burn-out coping, d4.6 with CoCr base

Screw-On abutment analog – 3D print, d4.6

Screw-On temporary coping, d4.6

Screw-On temporary coping, d4.6, set of 5 pcs. (without screws)

Screw-On Ti base, d4.6/d5.0

Screw-On Ti base, d4.6/d5.0, set of 5 pcs. (without screws)

Screw-On bridge screw AN/tx1.9
